Know what you have
Boilers heat water, and the water carries heat through pipes to radiators, baseboards or in-floor loops. They differ from forced-air furnaces, which heat air. Many homes in the area use furnaces, so boilers are a specialty, and it helps to find a plumber who services them.
Look at the label for the brand, model and year. Older cast iron boilers can last decades, while steel and some newer units wear out sooner.
Common faults and what they usually cost to fix
| Fault | Typical repair | Repair or replace? |
|---|---|---|
| Failed igniter | Replace igniter | Repair. |
| Circulator pump noisy or dead | Replace pump | Repair. |
| Expansion tank waterlogged | Replace tank | Repair. |
| Heat exchanger leak | Major repair or new boiler | Usually replace. |
| Repeated lockouts and rust | Diagnose first | Depends on age. |
A leak in the heat exchanger often ends a boiler's life. Everything else on the list is usually a part swap.
Call the 24/7 line and describe the problem. A dispatcher sends a licensed plumber.
The rule of thumb
Many plumbers suggest weighing the repair cost against the cost of a new unit. If the repair is a small fraction, fix it. If it approaches half of a replacement and the boiler is old, replacement often wins.
That is a guide, not a law. Fuel savings, comfort and reliability matter too, and so does whether parts are still available.
What higher efficiency really buys
A condensing boiler can be considerably more efficient than an older non-condensing one, but only if the return water is cool enough to condense. In a system with small radiators that need hot water, a condensing boiler may not reach its rated efficiency.
Ask the plumber to look at your radiators and loops. A good installer adjusts controls and, where it makes sense, adds outdoor reset to lower the water temperature on milder days.
Safety first
- Install carbon monoxide alarms on every level and near the boiler room.
- Keep the area around the boiler clear of storage.
- Have the vent and flue checked each year.
- Leave the house and call the gas utility if you smell gas.
- Do not relight a pilot that keeps going out.
Gas appliances should be serviced by a qualified professional. If you suspect a CO leak, leave the house and call 911.
Get two prices and a written plan
Ask for the cause of the problem in writing. Ask what parts are being replaced, what warranty applies and what happens if the repair fails. For replacement, ask about the vent, the condensate drain and any piping changes.
Our boiler repair page explains what a visit includes. For hot water only, water heater repair may be the right place to start.
Radiator and baseboard problems
A radiator that is cold at the top has trapped air. Use a radiator key to open the bleed valve slowly until water spits. A radiator cold at the bottom may have sludge. A baseboard run that clicks as it warms is expanding in its brackets.
If one zone is cold and the others are warm, look at the zone valve or the thermostat for that zone. If every zone is cold, the boiler or the circulator is at fault.
Pressure, water and expansion
- Cold pressure is often 12 to 15 psi, but read the label.
- Pressure that climbs when the boiler heats may signal a bad expansion tank.
- Pressure that falls means a leak or an auto-fill problem.
- A relief valve that drips needs attention.
- Repeated top-ups are a warning, not a fix.
Adding water over and over hides a leak and floods the boiler with fresh oxygen, which speeds rust. Find the leak first.
Maintenance that prevents January breakdowns
An annual check includes cleaning the burner, testing the safety controls, checking the vent and testing the relief valve. The water is checked for sludge, and the system may be flushed or treated.
Schedule it in September or October, before the first cold week, when plumbers have the most time. See boiler repair for a visit outline.
Fuel, flues and venting
Most residential boilers burn natural gas, though some burn oil. The flue carries exhaust out of the house. A cracked or blocked flue is a carbon monoxide hazard. Have it checked each year, and test your alarms.
When a boiler is replaced, the venting often changes. A condensing model uses plastic vent pipe through a wall, while an older boiler may use a masonry chimney that needs a liner.
Questions to ask before you approve a replacement
- Why does the boiler need replacing and can I see the damage.
- What size is the new unit and how was it calculated.
- Will the radiators or loops work with the new boiler.
- What is included in the price, including venting and disposal.
- What warranty covers parts and labor.
A heat loss calculation, not a guess based on the old unit's size, should decide the size of the new boiler. Oversized boilers cycle on and off and wear out faster.
Warning signs not to ignore
- Soot or black marks around the boiler.
- A yellow or flickering flame.
- Water pooling beneath the unit.
- Carbon monoxide alarm going off.
- A burning smell when the boiler starts.
Any of these is a reason to shut the boiler down and call. Safety comes before comfort.
Boilers beyond Carol Stream
Older homes in Wheaton and West Chicago are more likely to have hot-water heat than newer subdivisions, so boiler questions come up there often.
Whichever town you live in, record the boiler's make, model and install year. That one note speeds up every future repair call.
Heating season in northern Illinois
Carol Stream's housing grew rapidly between 1970 and 1990, from 4,434 to 31,716 residents, and many homes of that era use forced-air heat. Boilers are the exception, which makes servicing them a specialty.
If your house has radiators or baseboard heat, keep a record of the boiler's age and service history. It will help any plumber who comes in an emergency.
Questions readers ask
Do you repair boilers in Carol Stream?
Yes, residential hot-water boilers and their pumps, valves and controls.
Should I replace a boiler that is twenty years old?
It depends on condition, parts and repair cost. The plumber gives both prices.
What if there is no heat at night?
Call the 24/7 line. The dispatcher arranges a plumber and tells you the arrival window.
Is a condensing boiler worth it?
It can be, if your system runs cool enough to condense.
How often should a boiler be serviced?
Annual service before the heating season is common practice.
Standards and sources
This guide follows the Illinois Plumbing Code, 77 Ill. Adm. Code 890, and general manufacturer guidelines for the equipment discussed. Local facts come from the Village of Carol Stream, the DuPage Water Commission and the Daily Herald, as named in the text. Product instructions for your own equipment always take priority over general advice.
